How Much Do Peugeot Keys Experts Make? Peugeot 208 Key Replacement

It is best to delegate the replacement of Peugeot 208 keys to auto locksmiths equipped with the equipment and knowledge. They will be able to make and program new keys much faster than a dealership would and at a lower cost.

If your key fob stopped locking or unlocking your doors, it could be due to a dead battery in the coin. But, there are other reasons why the key might be malfunctioning.

Dead Coin Battery

A dead battery in the coin compartment will stop your Peugeot 208 from locking or unlocking and will not allow you to start the engine. If this is the case, you'll have to use the backup starting method that is detailed in the owner's manual of your vehicle.

Another reason your 208 might not be starting is because the spark plugs have been worn down. Spark plugs are what ignite the fuel to start the engine. They have a limited life span. If they aren't used enough, they will eventually fail.

Luckily, there is an easy solution for this problem. The best way to solve this issue is to measure the voltage of your car battery with a multimeter. If the voltage is below 11,5 volts, it's the time to replace it. If the battery is damaged it is crucial to clean its contacts. This can be done by removing the rubber cover from the two battery terminals, and then using a wirebrush, you can remove any damaged parts of the battery. Then, you must reconnect the positive pole cables to the negative.

Water Damage

If your 208 won't turn on and the battery isn't running, then make sure that the spark plugs are functioning. It is possible that they're dirty, causing them to not to spark. The spark plugs can be cleaned in a workshop.

Peugeot cars are equipped with keys that are transponder-type and is compatible with the car's immobiliser system. This ensures that only a valid key is able to turn the engine. If the chip inside the Peugeot key is damaged, it won't transmit the proper signal to the vehicle.

Water damage is a typical cause of this problem. This is especially prevalent in colder climates, where the vehicle may have been exposed to rain or snow. If this is the case, you should contact a reputable auto locksmith who has all of the tools and equipment required to modify the new key. They'll also have the latest technology and machinery needed to create the Peugeot smart key. The process shouldn't last more than 15 minutes.

Contacts to the battery are not working properly.

Peugeot replaced the old transponder chips using a new version that makes use of electronic components mounted on a circuit board. The new system works great when it's brand new, but the circuit boards degrade over time and cease to function properly.

www.thekeylab.co.uk could stop the immobiliser from activating so your vehicle won't be able to start. If this happens, it's recommended to seek out a Peugeot specialist or locksmith.


Another issue that is common is when the battery of the key fob starts to die, this causes the blade of the key to stop getting into the lock. A car locksmith can replace the battery and cut a new blade for you, this is usually a simple fix.

Faulty Receiver Module

If your Peugeot key fob has stopped working after dropping it on the ground, being exposed to a sudden rain or accidently washing it, it could be due to a malfunctioning receiver module. The receiver is responsible for transmitting radio frequency signals to an on-board computer that controls the central locking system within your Peugeot vehicle.

The key fob itself is fitted with rubber seals which prevent water from getting to the chip inside. However prolonged exposure to water can cause damage to these seals and the chip. The high salt content of the pool or ocean waters can cause damage to the key fob when it is submerged.

The module needs to be replaced if the Peugeot spare key is no longer working. This can only be completed by an experienced auto locksmith or Peugeot specialist. Peugeot keys like other cars are secured by an immobilizer device. This requires the right coding to start the car. This is why you should be able to trust a professional Peugeot locksmith with the task of programming and creating an alternative.

Computer malfunctioning on-board

The on-board computer in your Peugeot is responsible for many of the systems inside your car, from power windows to airbags. The on-board computer will display an error code when something goes wrong. The code will be stored within the system until the problem is fixed. This could mean that the on-board computers to be replaced.

One of the most frequent causes of the airbag light flashing is loose or corroded connection in the airbag sensor. This can be caused by wear and tear, aging, exposure to moisture and salt. It is crucial to get this issue addressed as quickly as you can, since the airbag malfunctioning could be dangerous in the event of an accident.

If you encounter the error "card not found" on your Peugeot key fob, the battery inside the key fob may be dead or weak. This will stop the key fob from sending a signal to disable the immobilizer on your vehicle. You can test this by pressing the unlock button on the key fob and then trying to start your car. If this doesn't work then the battery in the key is in need of replacement.