The 3 Most Significant Disasters In Peugeot 308 Key Fob History Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit but it's still attractive. It's not the plushest car in its class but the Ford Focus or Volkswagen Golf will help you stay away from sloping surfaces - however, it's a comfortable and comfortable drive.

We are often asked at Coded Car Keys to replace peugeot key fobs. If the issue is ongoing or continuous, the following tips should aid.

Water Damage

If you happen to leave your fob in a puddle or splash it with water during kayaking, swimming, canoeing, rafting, or canyoning, it's most likely to suffer water damage. The best method to prevent this from happening is to always keep it in a dry, dry bag when you're going outdoors or doing things where the fob might be exposed to excessive amounts of water.

It's also important to make sure the fob has completely dried out before you open the fob and then use it. If you notice any smells emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indicator that it is submerged.

A circuit that is wet can cause the battery's power to be depleted or even explode. If you can get the 308 keyfob from the water and turn it upside up and shake as much water as possible before opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab that has been dipped in 90-percent alcohol.

Other reasons that your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issue, signal interference or a defective chip. If none of the above are the issue, try resetting your system by disconnecting the battery with 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start systems which allows drivers to start their car from some distance, which allows them to warm up or cool down the vehicle prior to entering. This feature is extremely helpful, especially during cold winter months. The remote start system can cease to function for a variety reasons, including an inactive coin-battery.


The coin-shaped battery located inside the key fob could last between two and four months, depending on how frequently it is used, where it was purchased and how it is used. The date of use is typically printed on the package or in the manual.

If the key fob is no longer working after being exposed clean tapwater, take out the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing. If the key fob was exposed to salty or soapy water, it could have caused the chip to be damaged. You will need to replace it.

If you're not sure the battery is defective You can test its voltage with a multimeter that is set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is less than 12-13 volts then it is time to replace the battery. If you want to, you can try to reset the onboard computer by disconnecting the battery at 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should start.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible the receiver module has created a fault. It's the part that sends out an alert when the key fob is activated. It also acts as an alarm that stops the car from starting without the correct key.

The cause could be several reasons, such as water damage or just getting old. If your Peugeot 308 key fob was exposed to dirty tap water, for example the electronic chip located inside the device will be damaged. In this situation, you'll need to take the device apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.

If the problem persists it is recommended to visit an area Peugeot expert or locksmith. They'll be able make use of a diagnostic device to assist in identifying the problem and repair it for you.

The loss of your Peugeot car keys can be a stressful experience. However, a qualified auto locksmith can solve the issue in only a few minutes. They can cut a brand new key and programme it to your vehicle, so you're ready to get out on the road in the shortest time possible. Find a locksmith near you.

Electronic chip malfunctions

The electronic chip that is in the Peugeot 308 key fob plays a vital part in the remote control system. If it is damaged, your car might not start or you might receive a message that reads "anti-theft active". In peugeot 107 key fob , the only solution is to replace the key. Fortunately, auto locksmiths with experience can complete the task within the shortest period of time.

The chip inside your Peugeot 308's key fob could be damaged due to a variety of reasons, including sweat, water damage or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it needs to be cleaned as soon as possible. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery should then be allowed to completely dry.

Sometimes keys can cease to function due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This can be caused by problems with the environment or objects close to the vehicle. It is recommended to see a Peugeot dealer if you experience this problem.

The Peugeot key fob 207/308 is very delicate and requires extra attention. You should not drop it or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Unplug the negative cable prior to the positive.