15 Reasons You Must Love Nissan Qashqai Key Fob Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai's bigger dimensions give it an SUV feel. Its ride on 19-inch alloy wheels in Ti and STL versions may also be a bit firm. The front tyres of the Qashqai can lose grip on rough surfaces and its CVT may occasionally exhibit wrist-flexing torque steer.


nissan key replacement is usually caused by the battery being dead that can be replaced in a matter of minutes. Make sure the replacement battery is of the same voltage, size and specifications.

Water Damage

One of the most frequent reasons why a Nissan key fob will give the "key ID is not correct" message is due to water damage. The rubber seals on the key fob protect the chip's electronics, but prolonged exposure to moisture could cause it not to work correctly. It is common to observe this happen if your key fob was dropped into the water or a swimming pool. However, it could also happen when it gets wet from the rain or soapy hands.

If your key fob has been exposed to water for a long time, it may need to be cleaned using isopropyl alcohol, or electronic cleaner. It could also have to be sent to an expert to be repaired or replaced.

If your key fob requires to be replaced, it's a relatively simple procedure. Make sure you have the correct multipack (CR2032, 3V). Then, open the back and front cases with an abrasive screwdriver. It is necessary to remove the clips that hold the metal together and then push out the old battery, and then put in the new one. Reassemble the fob and replace the mechanical key. Check to see if it functions properly. If it doesn't it is necessary to take it to a local Nissan dealer or a professional auto locksmith to fix the chip in the key. Fortunately the chip isn't typically damaged by exposure to water, so this should not cost you a lot.

Dead Coin Battery

The coin battery is another common reason why your Nissan Qashqai remote key fob might not function. They last for three to five years, however they are prone to failure over time in the event that the fob has been frequentedly dropped. You can replace the battery but be sure to use the same voltage and same size as the previous. If you use a different battery it may cause the key to have an incorrect key ID, which can prevent it from pairing with your vehicle.

The most effective method of changing the battery inside a Nissan Qashqai Key Fob is to pry it open using an small screwdriver that has a flat head. The screwdriver should be inserted into a small hole on the bottom of your key fob. The screwdriver should be gently twisted to split the two halves. Then, take out the old CR2025 button cell battery and insert the new one after confirming its location in the fob.

Examine the terminals to see if there is dirt or water damage prior to installing the new battery. If there is, wash the terminals using a small amount of isopropyl alcohol. Make sure that the pole cables are properly connected. They should be connected both the positive and negative poles of your battery.

Troubleshooting

If your Nissan Qashqai's key fob stops functioning after exposure to water that is clean from a tap or rain, this could be a sign there's an issue with the internal chip. You'll require a new keyfob if you are unable to fix the issue by replacing the battery. If you dropped the key fob on the ground and it stopped working right away it's likely due to the damage to the internal chip. It is possible to get the key fob to work once again if it is removed and clean the chip with paper towel and isopropyl alcohol and then insert it back in.

Key ID Incorrect is a common mistake that you might see on the dashboard of your vehicle. The vehicle is not able to recognize the key fob and thus won't allow the vehicle to start. This problem could be caused in several ways, such as water damage, problems that are undetectable in the circuitry of the key fob or RFID interference.

The key fob will not function in the event that the batteries with 12 volts are dead or fail to provide enough electric current. This can affect your Nissan Qashqai's keyless system central locking, as well as the ability to start the engine using the key fob. Check the battery in the key fob in case you are not able to lock and unlock your door by hand. You could also try installing the battery again to reset your transmitter.

Reprogramming

If the key fob was not submerged in saltwater it should be able to be revived by a simple wash of clean water. You can also clean the electronic chip with isopropyl or electronic cleaner. If none of the above works then you might need to replace the key fob.

If your Nissan Intelligent Key still does not work, there could be a connection issue between it and your vehicle. To reconnect it, start by turning the key into the ignition, but not starting the car. Continue doing this until the hazard light flashes two times. Then, turn off your vehicle and remove the key.

Open the fob compartment of your vehicle's fob compartment. It is typically located in a door jamb, on the handle on the driver's side, or under an armrest. Find the small button labeled "program" and press it. After the program is complete you will hear an audible sound.

Now that your Intelligent Key is relinked to the car now is the time to try it out. Take a step away from the vehicle, and hit all the buttons on it. If the lights flash or the horn sounds, the key is connected to the Nissan. You may also try testing the key in close proximity.