Why You Should Concentrate On Improving Peugeot 308 Key Fob Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit however it's still appealing. It might not be the most luxurious car in its class It's it's a Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxed and pleasant driving experience.

We are often asked at Coded Car Keys to replace peugeot key fobs. The following suggestions will assist whether the issue is constant or intermittent.


Water Damage

If you accidentally drop your key fob into the puddle, or it is wet while kayaking, canoeing, rafting or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in things that expose it to a lot of water.

You'll also want to make sure that the fob is dry prior to opening it and reusing it. If you detect any smells emanating from the fob such as an industrial-type liquid smell or windshield washer fluid, this is another indication that it's been submerged in water.

A circuit that is wet can cause the battery's charge to be drained or even explode. If you can get your 308 keyfob out of the water it is best to turn the button side up and shake as much water out as you can prior to opening the casing. Take the battery out, and then wipe the circuit board clean with a cotton swab that has been dipped in 90-percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system might not function include a dead battery for your coin, receiver module issues signal interference, an electronic chip malfunctioning. If none of these is the issue, try resetting the system by removing the 12 volt battery for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start systems which allows drivers to start their car from some distance, which allows them to warm up or cool down the car prior to entering. This feature is very beneficial particularly in cold winter months. Remote start systems can be stopped for a variety of reasons, including a dead coin-battery.

A coin-shaped battery located inside the key fob will last a time of between two and four years, depending on how often it is used and the location where it was purchased. The date of use is usually found on the packaging or marked in the manual.

If the key fob is not functioning after exposure to water that is clean then you must remove the battery, then clean the chip using a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to soapy or salty water, it may have fried the chip. It is recommended to replace it.

If you're not certain the battery is faulty you can check its voltage using a multimeter that is set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is lower than 12-13 volts then you must replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.

Faulty Receiver Module

If you aren't seeing the "Key Detected" message, it could mean that your receiver module is defective. It's that part that sends a signal to the car when your key fob is activated which acts as an immobiliser. It also stops it from starting unless the correct key is present.

The cause could be a number of factors, including water damage or just the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, like the chip that is located inside is damaged. In this case you will need to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the problem persists the issue persists, it's a good idea to visit an area Peugeot specialist or locksmith. They will be able to make use of a diagnostic device to help pinpoint the issue and fix it.

Losing your Peugeot keys to your car can be an incredibly stressful experience. A certified auto locksmith will be able to solve the issue in minutes. They can program your car and cut a brand new, functioning key for you. Find the nearest locksmith.

A malfunctioning electronic chip

The electronic chip inside the Peugeot 308 key fob plays a crucial function in the remote control system. If it gets damaged, your car might not start or you may receive a message saying "anti-theft active". In this scenario, the only solution is to replace the key. Luckily, professional auto locksmiths can offer the service within the shortest period of time.

peugeot key G28 in the key fob of your Peugeot 308 may become faulty for many reasons, including sweat, water damage or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must clean it immediately. You can use a paper towel and isopropyl ethanol to clean the electronic component. After that, allow the battery to completely dry.

Sometimes, a key fob can cease to function due to radio interference. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are near to the vehicle. It is recommended to see a Peugeot dealer if you have this issue.

The Peugeot 207/308 Key Fob is delicate and requires particular care. You should not drop it or throw it around. If you lose something, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Be sure to disconnect the negative first, and then the positive.