4 Dirty Little Tips On The Peugeot 308 Key Fob Industry Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a bit, but it still feels attractive. It's not the most luxurious car in its class, but it's a pleasant and peaceful driving experience.

We are often asked at Coded Car Keys to replace peugeot key fobs. If the issue is intermittent or constant, the following tips should assist.

Water Damage

If you leave your key fob in a pool or splash it with water when kayaking, swimming, canoeing, rafting or canyoning, it's likely to suffer water damage. The best way to prevent this from happening is to keep it in a dry bag when you're outside or performing activities in which the fob may be exposed to excessive amounts of water.

It's also crucial to make sure the fob has completely dried before you open the fob and then use it. If you detect any smells coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another sign that it's been submerged in water.

G28 Car Keys could cause the battery's power to be depleted or even explode. If you're able fish your key fob 308 out from the body of water it was stuck in it, flip the button side down and shake it out as much water as possible before opening the case. After you open it, take off the battery and wipe down the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could fail to function include the battery of your coin is dead or receiver module issue signal interference, an electronic chip that is damaged. If none of these causes the issue, try resetting your system by disconnecting the battery with 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start systems that allows drivers to start their car from some distance, which allows them to warm up or cool down the vehicle prior to entering. This feature is extremely beneficial, especially during cold winter months. The remote start system can not function due to a variety of reasons, such as the battery being dead.

A coin-shaped battery that is located inside the key fob can last for a period of two to four years, based on how often it is used and the location where it was purchased. The date of use is printed on the packaging or mentioned in the user's manual.

If the key fob stopped functioning after being exposed to clean tapwater, remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then dry the chip thoroughly before replacing it. If exposed to salty or soapy water, the chip could be damaged and you'll need to replace the key fob completely.

If you're not sure that the battery is not working properly you can check the voltage with a multimeter set to your car's voltage range. Connect it to the minus and plus terminals. The voltage should be around 12 to 13 volts, but if it's lower, the battery must be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start after this.

Faulty Receiver Module


If you're unable to see the "Key Detected" message on your dashboard, then it's possible that your receiver module has been afflicted with a fault. It's the part that sends an indication to the car when your key fob is activated, which acts as an immobiliser, and stops it from starting until the correct key is in place.

This could result from a variety of causes including water damage or simply aging. If the chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water, it could be because the keyfob was exposed to it. In this case it is necessary to take the device apart and thoroughly clean it with isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue persists, it's probably a good idea to seek out an area Peugeot specialist or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.

It is stressful to lose your Peugeot car key. A qualified auto locksmith can solve the problem within minutes. They can cut a new key and program it to your vehicle, so you're to the road in the shortest time possible. Click here to locate the nearest locksmith.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob plays a crucial part in the remote control system. If the chip is damaged, you could experience difficulties starting your vehicle or receive a message saying "anti-theft". If this occurs, the only way to fix the issue is to get a new key. Fortunately, auto locksmiths with experience can complete the task in the shortest time.

The chip in the key fob of your Peugeot 308 could be damaged due to a variety of reasons, such as sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, clean it immediately. You can make use of a towel and isopropyl alcohol to wipe the electronic component. The battery should then be allowed to completely dry.

Sometimes, a key fob can not function due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. This can be caused by unsafe conditions or objects that are within the vicinity of the vehicle. If you experience this problem it is recommended to visit an Peugeot dealership.

The Peugeot key fob 207/308 is extremely delicate and requires a lot of care. It should not be dropped or throw it around. If you lose something, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Disconnect the negative cable before the positive.