What's The Most Common Nissan Qashqai Key Fob Debate Could Be As Black And White As You May Think Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV-like appearance due to its larger dimensions, and the wheel sizes of 19 inches in Ti and ST-L models can be a bit firm at times. The front tyres could lose grip on rough surfaces and its CVT may occasionally exhibit wrist-flexing torque steer.


It is usually due to dead batteries that can be replaced in a matter of minutes. Make sure the replacement battery is the same size, voltage, and specification.

Water Damage

Water damage is one of the most frequent causes for the Nissan keyfob to display the "key ID is wrong" message. The rubber seals on the key fob shield the electronic chip, but prolonged exposure to moisture could cause it not to work effectively. It's typical to observe this if your keyfob was dropped into the water or in a swimming pool. However, it can occur when it's wet due to rain or soapy hands.

If your key fob is exposed to water for a prolonged period of time, it might need to be cleaned using isopropyl alcohol or an electronic cleaner. It might also need to be sent to a specialist to repair or replace it.

If your key fob is in need to be replaced, it is an easy process. Make sure you have the proper multipack (CR2032, 3V). Open the front and rear cases using a flathead screwdriver. Remove the clips made of metal, then remove the battery, and then replace it. Reassemble the fob and replace the mechanical key. Check that it works properly. If not it, you'll need to bring it to an Nissan dealer or a professional auto locksmith for the replacement of the key chip. The chip isn't usually damaged by water so it shouldn't be too expensive.

Dead Coin Battery

The coin battery is another frequent reason why your Nissan Qashqai remote key fob won't work. They typically last for 3 to 5 years but can go bad over time, especially if the fob is frequently dropped. You can replace the battery, however, make sure it's the same voltage and same size as the previous. If you replace the battery, it could cause the key to be assigned a wrong key ID. This will stop it from being linked to your vehicle.

The best method to replace the battery of a coin on the Nissan Qashqai key fob is by opening the key fob using a small flat head screwdriver. The screwdriver should be inserted into a small notch on the bottom of your key fob. Make sure to gently twist the screwdriver to split the two halves. Remove the old CR2025 battery and replace it with a new one, noting the position of the old battery in the fob.

Before you put the new battery in place check to ensure there isn't any dirt or water damage to the terminals. If this is the case, clean the terminals using the smallest amount of isopropylethanol. Make sure that the pole cables are properly connected. They must be connected to the negative and the positive poles of your battery.

Diagnostics of a fault

If your Nissan Qashqai's main fob stops functioning after being exposed to pure rainwater or clean tap water, this could indicate that there's an issue with the internal chip. A battery change won't solve this issue, and you'll have to purchase a new key fob. If the key fob stopped working after you dropped it, it is likely that the chip inside was damaged. It is possible to get the key fob back to work again if you remove and clean the chip using paper towel and isopropyl alcohol, then put it back in.

A common error that you might see on the dashboard of your vehicle is "Key ID Not Correct." The vehicle is unable recognize the key fob, which is why it won't allow the car to start. The issue can be caused by a variety of things like water damage, undetectable malfunctions in the key fob's circuitry or RFID interference.

If the battery that powers 12 volts in your key fob is dead or not providing enough electrical current it will cease to function. This could affect the remote keyless system as well as central locking on your Nissan Qashqai, as well as preventing you from starting the engine using the key fob (if equipped with Intelligent Key). Check the batteries in the key fob if you are in a position to lock or unlock your door by hand. Try installing nissan qashqai replacement key to reset your transmitter.

Reprogramming

If the key fob is not been submerged in salt water the device should be able to be restored to its original state after a quick wash with clean water. You can also try cleaning the electronic chip using isopropyl Alcohol or an electronic cleaner. If these don't work it could be time to replace the entire key fob with an entirely new one.

If your Nissan Intelligent Key is still not functioning, there may be an issue with the connection between it and your car. Start by pressing the ignition key, but without activating the vehicle. Continue doing this until you see the hazard lights flash twice. Turn off your vehicle and remove the key.

Open the fob compartment in your vehicle's fob compartment. This is usually located in a door jamb, on the driver's side door handle or under an armrest. Locate the small button labeled "program" and press it. You will hear a sound when the process is completed.

Now that your Intelligent Key is relinked to the car now is the time to try it out. Click all the buttons on the key while you are at a distance from the car. If the lights flash or the horn sounds, the key is connected to the Nissan. You can also test it near the Nissan.