What Is Everyone Talking About Kia Picanto Key Fob Replacement Right Now How to Replace a Kia Sportage Replacement Key

For a variety of Kia models, the key contains a built-in keyless entry system. The key is usually akin to the remote control and is able to be replaced with a brand new one from an Kia dealer or a locksmith.

Key fobs may stop working for several reasons, including the battery of the coin is dead, worn buttons water damage, signal interference and a damaged receiver module. Here are some helpful tips to help you get your Kia key fob that is a replacement for the sportage again.

How to replace the remote key or smart key

The battery inside your Kia's smart key will eventually need be replaced, regardless of whether it's a remote key, a push-to-start key or a regular key that doesn't have an electronic transponder. This is especially when your car shows a message that states the smart or remote keys are in poor condition.

Fortunately, it's an easy procedure. To replace the keyfob battery remove your mechanical key from the slit at the back of the fob. Then, you need to pry the cover open. A small screw is located inside the key fob to keep the battery in place. By using a small screwdriver remove the screw and remove the battery that was in place. Install the new battery and close the opening on the key fob.

Once the key fob has a fresh battery Test it by pressing the locks and unlock buttons. It's good If the doors lock and unlock as expected. You can now use the hands-free feature to lock and unlock your Kia whenever your fingers start to get cold or you have to go on errands around Brandon.

Note: g28carkeys.co.uk might need to be programmed (transponder chips or smart keys). This requires a specific programming machine that only the dealer or locksmith has access to. Other keys (non transponder keys made of metal) don't require programming. If your keys need to be reprogrammed, you will need to be aware of the key code number printed on the key code tag and keep the number in a secure place.

How to replace a battery

If the Kia key fob doesn't respond to pressing the lock/unlock button, it is likely that the battery is low. A battery that is not functioning properly could cause other issues, such as the check engine light flashing on or delayed cranking of the engine. Fortunately replacing the battery on the key fob is a simple DIY project that requires only a few tools.

Make sure you turn off your vehicle and close the doors before you begin. Find the small metal or plastic piece at the bottom of the key fob. Move it until the metal key pops out. The key can be put into the driver door handle to unlock your car.

To replace the key fob battery, take off the cover on the rear and use a plastic bar tool to release the latch holding the black negative battery cable. Remove the old battery and then orient the new battery so that the "+" positive side faces your face and the "-" negative side is facing towards the fob's electronic contacts. Avoid using excessive force when pushing the new CR2032 into position to avoid damage or bending the metal contacts.

After the new battery has been installed, turn the key fob off and then turn it on in the ignition repeatedly until the door locks cycle. Then, you can test your Kia key fob to check if it is working properly again.

How do you replace a keyless key

You may have either a standard keyfob or a Smart Key based on the model of Kia Sportage. The smart key has an embedded mechanical key blade while the standard key fob does not. Both kinds of key fobs come with a battery inside them which eventually needs to be replaced. It's a fairly simple process that only takes about two minutes.


Be sure to switch off your Kia and stand on a flat, well-lit surface before you begin. Keep in mind that there are tiny parts inside the fob that could be removed if not careful.

The release button for the small size is located on the lower backside. This will be either a circular button or a rectangular slot. After pressing this button mechanical key blade, it will come out and you can then open the key fob.

After the key fob has been opened, take out the battery. The new battery should be a CR-2032 and can be purchased online or at your local auto parts store. When you are done you should be able to lock and unlock your vehicle with your key fob - even if your engine isn't running!

How do you replace the mechanical key?

The Kia key fob is a great convenience that allows us to lock and unlock our car with the push of an button. But like any device, it can have problems occasionally. There are solutions to fix these problems and keep your key fobs in good working order for a long time.

One of the most frequently encountered issues is a low or dead battery. This can cause the fob to stop working completely or work intermittently. If this happens you should replace the battery with a fresh new one.

If this does not solve the problem, use a flathead screwdriver standard to wedge the fob's plastic casing open. Be careful not damage any internal components or scratch the plastic. After opening, carefully remove the battery you have been using and replace it with a brand new one.

Close and open the door with the mechanical key. (Every kia fob comes with an emergency mechanical key which will fit into the slot). Test the key fob and check that it's functioning correctly. If the key fob not working, contact an authorized locksmith or dealer to resolve the problem. To avoid lockouts in the future, make sure you get an emergency key that can be able to work with all door and trunk cylinders.