10 Instagram Accounts On Pinterest To Follow About Double Glazing Windows Repairs Double Glazing Windows Repairs

Double glazing is the term used to describe panes of glass within the frame of a window or wall opening. Sometimes, this window glazing is damaged and requires repairs.

If you've noticed condensation between the windows or a noticeable draught, or hinges or handles are becoming difficult to open These are all indications that your double glazing needs to be repaired. The repair typically involves a resealing of the entire unit.

Broken Panes

Double-glazed windows comprise of two glass panes, with an air gap which is filled with inert gases, such as Krypton or argon. This helps keep heat in your home and blocks cold drafts from getting in. Sometimes windows get damaged and when this happens, the entire window might require replacement. It is essential to call the company that sold you double glazing immediately if you notice a chip or crack in the window.

It is possible to repair damaged glass by following a few easy steps, but it's not recommended unless you have previous experience in DIY. Put on some gloves first and then carefully remove the damaged window pane. If it's cracked apply strips of masking tape across the areas that are cracked in a crisscross design. This will stop the cracks from becoming worse over time, particularly in the winter. You should also cover your work surface in newspapers to prevent any broken pieces from falling. After the broken pane has been removed scrape off any glazing putty or glazed window seal using a putty knife and remove the glazing points using pliers. Then, apply a primer that dries quickly to coat the bare wooden surface.

If you're able to purchase a new replacement pane you can measure the length and width of the channel with a tape measure. Subtract 1/8" from both measurements to take into account the slight movement of the replacement pane. Next, roll a narrow rope of glazing compound into the grooved channels and slide the replacement glass into place. Tap window repairs with a hammer every 6" or 8" to aid in setting it in place. Be careful not to break it.

If you have a double glazing warranty it is often worthwhile to try using this to avoid the cost of a complete replacement window. The warranty typically covers the cost of any component that you may require replacement, as well as labour. You should check the details as they will vary from one company to the next.

Foggy Glass

Condensation in the panes of your double glazing can cause foggy glass. It can be caused by a variety of factors, including temperature fluctuations, in the event that the frames aren't fitted correctly, and even ageing of the seals themselves.

The good news is that in the majority of instances this issue can be resolved easily by a professional double glazing installer. Contact the company who installed your windows immediately if you spot any issues. Follow up with a written response. It will be much easier to reach out to the company if you need to contact them later. This is also helpful if your warranty or guarantee covers the issue.

The most effective method to eliminate the fogging is to replace the gasket seals - this can be done without the need to replace the entire window unit, and will aid in keeping your home energy efficient. The window glazier should first remove the clips or retaining strips which hold the IGU and then make use of the saw to cut through the sealant that was previously used.

Then they'll construct or order a replacement IGU to fit the frame, and use specific sealants to ensure that it's air- and water-tight. After they're done installing the clips, they'll either reinstall them or strip and apply more sealant.

If you're lucky, the misting will stop. However, it's important to ensure your frames are properly ventilated so that water doesn't get trapped in your walls and ceilings.

Another frequent issue reported by double glazing owners is that their doors or windows become difficult to open and close This could be the result of extreme weather, or it could mean that the frame has dropped or sagged slightly over time, and isn't at a level with the rest of your home. If this is the problem you can try wiping down the frames using cold water to shrink them a bit. But this won't solve the problem completely. If you aren't able to solve the issue away, you might require replacement by an expert.

Condensation

Condensation happens when the insulating gasses in double glazing windows do not hold their place, leaving moisture and air between the panes. This is more prevalent in winter as humidity levels are higher. However, it can also happen at other times. The accumulation of moisture can lead to mildew and mould around sills, sealants and window frames which are not only ugly but also hazardous to your health. The good thing is that condensation can usually be sealed by a window expert to help reduce moisture in your home and stop the build-up of moisture.

Window gaskets are a crucial part of any double-glazed window or door. These gaskets seal in the air-tight space between the window glass to prevent drafts or moisture and heat from entering or leaving your home. Gaskets can degrade or shrink over time due to temperature fluctuations, weather conditions and ageing, meaning that condensation could be appearing on your double-glazed windows or doors.


It is possible to fix this, but it will likely require replacing the sandwich (thermo-pane and glass) of your double glazed window with a replacement that is exactly. Unless you have the right tools to do the job it is recommended you hire a professional to re-seal your double-glazed windows.

Mist between your double glazed windows is another issue that is difficult to repair. This is an indication that the factory vacuum seal has failed and there is no way to get air out or in the sandwich.

Professionals will reseal the window with the same method they use to resolve problems with condensation or fog. This typically involves removing the thermo-pane sandwich, spraying it with a cleaning solution, then sucking the sealant out of the old. It is essential to accurately measure the'sandwich' in length width, thickness and length to ensure that the replacement will be a perfect fit, and a new seal can be drawn between the glass.

This is a challenging job that requires tools not typically found in DIY stores. It is recommended to delegate this job to professionals, since faulty seals can lead to mold and damp in your home. This can be costly and hazardous to your health.

Water Leaks

If you see water leaks around your double-glazed windows, you must respond quickly. If you don't act quickly even the tiniest leak could become a major problem.

The window frame could be the culprit. Check that the sill pan which is the flat bottom of the window frame, is pitched so that water runs away from your home and not into the frame. If you see that the sill pan has not been set correctly or you see water in the wood, you should contact an expert in double-glazing repair.

Another reason for water leaks is a damaged window seal. This can be caused by weather, age, or damage. This is not an easy fix and should be left to experts.

A broken window seal can let air through the windows which makes it less efficient in energy use. This allows cold air to enter your home in winter and hot gas to escape in the summer. This can lead you to high heating and cooling costs.

The most straightforward solution is to apply a new layer of caulking. Although people who have DIY skills can do it themselves, it is usually easier to have a double-glazing specialist take care of it. You will have peace of mind and you can be sure that the job was done properly.

Some double-glazing windows come with warranties up to 20 years. It is best to contact the company who sold you your windows to find out what warranties they offer and how long it lasts. You can avoid the expense of having to replace double-glazed windows later on. If your double-glazed windows are covered under a warranty, it is important to register the issue with them immediately you spot any issues. This can be done online or by contact with the company directly. The information you have in writing will be helpful if you ever need to use your warranty.