The Nissan Qashqai Key Fob Awards: The Most, Worst, And Strangest Things We've Ever Seen Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV-like feel due to its larger dimensions, and the ride on 19-inch wheels in Ti and ST-L models may be a bit stiff at times. The front tyres could lose grip on rough surfaces and its CVT can occasionally display wrist-flexing torque steer.

It is usually caused by an inoperable coin battery, which can be replaced in minutes. Make sure that the replacement battery is of the same voltage, size and specification.

Water Damage

Water damage is among the most common reasons for the Nissan keyfob to display the "key ID wrong" message. The key fob is fitted with rubber seals which protect the chip inside, however prolonged exposure to moisture can cause it to cease functioning properly. It's typical to observe this if your key fob was dropped in the water or in a swimming pool. However, it can occur when it is wet due to showers or soapy hands.

If your key fob has been exposed to water for a long period of time, you may need to clean it with isopropyl, or an electronic cleaner. It could also have to be sent to a professional to be repaired or replaced.

If your key fob requires to be replaced, it is a relatively simple procedure. First, make sure you have a multipack of the correct battery (CR2032 3V). Then open the front and back cases using the small flathead screwdriver. You'll need to take out the clips that hold the metal together and pull out the old battery and replace it with the new one. After reassembling your fob, put the mechanical key back into place and verify that it is working correctly. If it does not, you will need to take it to your local Nissan dealer or an expert auto locksmith to replace the chip on the key. The chip is not usually damaged by water and should not cost a lot.

Dead Coin Battery

Another reason that your Nissan Qashqai key fob may not work is that the battery inside is dead. They last for three to five years, but can become faulty over time in the event that the fob has been frequently dropped. You can replace the battery with a new one, but make sure that it's the same size and voltage as the original. If you use an alternative battery, it could cause the key to have an incorrect key ID that could hinder it from connecting to your vehicle.

The most effective method to replace the coin battery on a Nissan Qashqai key fob is by opening the fob with a small flat head screwdriver. Insert the screwdriver into a small notch on the bottom of the fob and twist gently to separate the two halves of the key fob. Then, remove the old CR2025 button cell battery and replace it with another one after confirming its location in the fob.

Examine the terminals to see if there is water damage or dirt before installing the new battery. If not, clean the terminals using some isopropyl ethanol. Make sure that the pole cables are connected correctly. They should be connected to both the positive and negative poles of your battery.


Fault Diagnosis

If your Nissan Qashqai's primary fob isn't working after exposure to clean tap or rain water it could indicate that there's a problem with the internal chip. The battery replacement won't fix this, and you'll need to purchase another key fob. If the key fob stopped working after you dropped it, it's likely that the chip inside was damaged. If you clean the chip using isopropyl ethanol and paper towel and then put it back in the key fob, it is possible to usually get it working again.

Key ID Incorrect is a typical error that can be seen on the dashboard of your car. This means that the vehicle cannot recognize the key fob, and will not allow it to start the engine. This problem could be caused in numerous ways, including water damage, problems that are undetectable in the key fob circuitry or RFID interference.

If the 12 volt battery on your key fob is empty or isn't supplying sufficient electric current, it will stop working. This can affect the remote keyless system and central locking of your Nissan Qashqai, as well as preventing you from starting the engine with the key fob (if equipped with Intelligent Key). Check the batteries in the key fob in case you are in a position to lock or unlock your door manually. You can also try replacing the battery to reset your transmitter.

Reprogramming

If the key fob had not been submerged in salt water the key fob should be able to be revived after a simple wash with clean water. You can also clean the electronic chip using isopropyl or electronic cleaner. If none of these works then it might be time to replace the entire key fob with a new one.

If your Nissan Intelligent Key still does not function, there could be a connection problem between it and the vehicle. To reconnect it, begin by turning the key in the ignition, without turning on the car. Repeat this process until the hazard light blinks twice. Turn off the vehicle and take off the key.

Next, you must open the fob compartment inside your vehicle. This is usually located in a door jamb on the driver's side door handle, or under an armrest. Find nissan key replacement near me marked "program" and press it. Once the process has been completed you will hear the sound of a chime.

It's time to test your Intelligent Key to the test. Stand some distance away from the vehicle, then hit all the buttons on it. If the lights flash and the horn sounds it means the key has successfully linked to the Nissan. You can also test it close to the Nissan.