Responsible For The Window Repair Budget? 12 Ways To Spend Your Money Why Window Repair Is Necessary

Cracks in window glass can be caused by a pebble that was thrown from the lawnmower, or a heavy beverage placed on the table that has a glass top. A damaged window may allow wind, rain, bugs and other undesirable elements to get into your home.

Although it is impossible to make a window that has been damaged completely invisible, there are ways to repair it and prevent it from becoming worse.

Water Damage

If water is seeping through your windows replacing them is typically required. Moisture can cause rot to the wood of the frame of your window. It can also reduce the energy efficiency of your windows. A reputable window replacement service can replace your frames without causing damage to them.

Wood rot is another problem that affects both the interior and the exterior of your window. If you have wooden windows with rotting areas, it may be possible to repair them if they're not terribly damaged. If the rot has gotten to the mullions and muntins, (the parts of the window frame that hold your glass panes) it could be necessary to replace the windows. This could cost more than a new set windows.

A deteriorated seal between the double-paned window panes is another issue that requires replacement. This could be the result of condensation or debris between the two panes, or it could indicate that the insulation in your window has failed. Fortunately, a lot of modern windows have insulation built into them. This means they don't face the same issues as older multi-paned windows.

Casings that are ugly, such as those that are cracked, loose, rotten, or missing, can create other problems. A damaged casing alone doesn't mean it's time to replace your windows, however. Depending on the condition of your casing as well as the wood surrounding it you may be able to sand it and repaint it to enhance its appearance.

If your exterior casing is in poor condition It is possible to apply a new coat of weather-resistant paint to stop moisture from causing damage to the window. The installation of new exterior casings can be an attractive and functional improvement to your home.

Paint chipped or peeling

Window frames and sills are usually close to the elements, which means they are subject to a lot of abuse from sunlight and precipitation. Moisture is the main reason for the peeling of paint around windows, particularly if the wood is exposed. The water seeps into the wood and when it evaporates, the pressure beneath the paint film causes it to peel and lose adhesion. The moisture may be caused by condensation in the interior, or rain and snow outside. It is important to scrape and sand the surface as soon as you see the paint start to chip. Some meticulous painters apply a water-repellent preservative, or thinned boiled linseed oil to the wood before painting to reduce the penetration of moisture and allow the paint to hold better.

When paint starts to peel off, it's time to repair your window. Before applying a new coat, lay a drop cloth or tarp over the area you're working to catch any scattered drops of paint. Using a utility knife, carefully scrape off any paint that is loose. Be careful not to cut the wood below or cut into the sheathing beneath. Let the area dry completely after scrubbing it thoroughly.

After the area has dried then sand it once more using a fine-grit sanding block. This will prepare the surface to receive primer and create a substrate ready for paint. Use the correct safety equipment when using paint based on lead. Clean the sanded area and tape off any adjacent surfaces like baseboards to shield them from paint.

You can then prime and paint according the instructions on the tin you are using. Make sure to adhere to the curing and temperature guidelines on the paint, as these will vary by type. Finally, be window repair near me to paint the exterior with an exterior-grade paint and the interior with an interior-grade.


Window replacement can be costly, but repairing chipped or peeling paint is affordable and can be a viable alternative to replacing the entire frame. If your window frames are damaged beyond repair however, it might be worthwhile to upgrade them to newer, more energy efficient windows.

Cracked glass

A broken window leaves your home vulnerable to winds, rain and bugs. You may be tempted to replace the glass, but you can also repair it yourself if you don't have too large a crack or break. It is important to address small cracks as soon as you notice them prior to them getting worse due to temperature changes or the passage of time.

There are many ways to make broken glasses appear as if they are not there. But, this is not a project that can be completed by a DIYer. A small crack can create a weak spot in the window, which could result in further cracks and a costly replacement. Covering the crack with plastic is a great solution. It covers the crack from the outside and prevents moisture or air from seeping through, which could damage the frame or seals around the windows.

Before putting on the plastic, put on your gloves and safety glasses and remove the broken pane of glass from its frame. You'll require an utility knife, scraper or chisel for removing any old glazing points that hold the pane into place. Utilize the knife to cut away any wood that is bare, and then seal it with linseed or a clear wood sealer.

You can then apply epoxy to glue the glass back into place. This method is the most time-consuming, but will give your glass a more solid appearance. When using epoxy, choose the double-cylinder model that distributes the resin and hardener in a similar proportion. This allows you to determine exactly how much applied to the glass which ensures a strong seal.

If you have double- or triple-pane windows, be sure that the gas fills are intact when you resetting the glass. These gases are essential to insulating and keeping heat inside your home in the winter and outside in summer. If you remove the glass these gases will escape through the crack, causing the window to lose energy efficiency. You can replace the gas fills by using the same method used for repairing cracks in other types of glass.