10 Seat Keys Replacement Tricks All Pros Recommend Seat Alhambra Key Problems

Seat's jumbo MPV family is among the best in its class when it comes down to resales values. With a new model currently on sale the Jumbo family MPV is better.

There are many reasons why the key fob won't work properly, including the battery being dead or water damage to the receiver module or signal interference. This article will walk you through the steps to make sure it works.

Water Damage

If your key fob for the seat alhambra survives washing cycles, a dip in the ocean or a pool, then it is equipped with a waterproof chip. But, you shouldn't do this often since prolonged exposure to water increases the chance of the key fob getting damaged. If the key fob ceases to functioning after exposure to clean water from the tap or rain, then just remove the battery, clean the electronic component with paper towel and allow it to dry completely before putting it back into. If the key fob has been exposed to soapy or salty water and salty water, it is recommended you clean the chip with isopropyl or electronic cleaner.

Faulty Receiver Module

If the key fob will not lock or unlock even after you've replaced the battery of the button it could be that the receiver module has a fault. It's a simple and inexpensive fix. It is possible to disconnect the 12 volt battery for a few minutes (first remove the negative cable, then press the horn numerous times) to drain any remaining power. Then reconnect seat ibiza keys in reverse. positive cable first and then negative.

ESP Warning Light - If the ESP warning light is flashing, this is normal and means that the car is travelling over terrain where the traction between the road surface and tyres aren't as good, like gravel, snow or lots of surface water. If the ESP light is constantly on, it indicates that there is a flaw in the system. This can be diagnosed with a iCarsoft i908 seat OBD code reader kit. It will provide you with a a detailed fault description.

Dead Coin Battery

One of the most frequent reasons for the seat alhambra keys to stop functioning is a dead coin battery. The key fob contains a small button cell battery that keeps it powered. Replace it with a new battery with the same voltage, size and specification as the original. When replacing the battery on the key fob, remove the metal clips and make sure that the contacts of the key fob are in good condition and free of corrosion.


If the key fob was exposed to water, like rain or soapy water, it's recommended that you remove the battery and clean the electronic chip with isopropyl alcohol or an electronic cleaner prior to putting in the new battery. The chip may be permanently damaged by moisture. If the key fob is still not working after replacing the battery, it could be necessary to replace the entire key fob.

Faulty Receiver Module

If your key fob stopped working after replacing the battery, but it did not function, or stopped working abruptly, your receiver module could have developed a problem. The receiver module receives radio frequency signals from your remote keyfob and transforms them into electrical signals which are then acted upon by other modules within the car.

If the receiver module has developed a fault it will not respond to any of the commands received by your remote key fob. In this situation it is necessary for a dealer to reprogramme the key fob, and also install an entirely new receiver.

The key fob features rubber seals that block water from entering the chip inside. If you immerse the key fob into salted or soapy water it could cause damage to the chip. If your key fob won't work, try cleaning the chip with isopropyl or electronic cleaner.

If the keys are connected but the receiver module has developed a fault you may try to restart all of the onboard electronics by removing the battery with 12 volts for a short period of time. Then reconnect the battery in reverse order (negative cable first, then positive). This resets all the electronic components on board and restore their functionality.

Electronic Chip Faulty

The key fob has a small electronic chip that transmits a message to the receiver module whenever the key is used. If the signal doesn't match the one that the car has stored the immobilizer will turn off and stop the vehicle from starting. If, however, the key fob is not working and you are unable to reprogram it this could be due to a defective chip.

The chip inside the key fob may have to be changed in order to get it working again. This can be done by taking the key fob out of its case, and using a needle or pin to connect with each metal retaining clip. If they are corroded or broken, you will need to replace them in order for the remote control to function. Make sure any replacement batteries are of the same size, voltage and specifications as the original.

The Seat Alhambra is a well-designed and popular model but like any other car it may encounter issues with particular parts or equipment. There have been reports of problems with the automatic climate control system. It is prone to fail and get stuck in a specific setting. The infotainment system may also malfunction and freeze the screens.