Why Adding A Peugeot Keys To Your Life Will Make All The Difference Peugeot 208 Key Replacement

It is best to delegate the replacement of Peugeot keys for 208 to auto locksmiths equipped with the necessary equipment and technical knowledge. They will be able to make and program new keys much quicker than a dealership and at a lesser cost.

If your key fob has stopped locking or unlocking your doors, it could be due to a dead coin battery. However, there are many other reasons the key could be malfunctioning.

Dead Coin Battery

A dead coin battery can prevent your Peugeot 208 from locking or unlocking, and will not start the engine. In this instance you'll need use the alternative starting method that is described in the owner's manual.

Another reason why your 208 might not be starting is because the spark plugs are been worn down. The spark plugs ignite the fuel to start the engine. However they have a short lifespan. valet key will eventually break down in the event that they aren't utilized enough.


There is a straightforward solution to this problem. Check the voltage of your battery using a multimeter. If the voltage is below 11,5 volts then it's time to replace it. If the battery is damaged it is crucial to clean its contacts. This can be done by lifting the rubber covers that cover both battery terminals and using wire brushes to clean any corroded parts of the battery. Then, you must reconnect the positive and negative pole cables.

Water Damage

If your 208 doesn't start and the battery isn't flat, then you need to make sure that the spark plugs are in good working order. It could be that they're dirty and don't spark. This can be fixed easily by cleaning the spark plugs in an workshop.

Peugeot cars use a key with a transponder compatible with the immobiliser. This ensures that only a valid key is able to turn the engine. If the chip in the Peugeot key is damaged then it will not send the correct signal to the vehicle.

Water damage is a typical cause of this issue. This is a typical issue in more cold climates where the car is exposed to rain or snow. In this situation, contact a trusted locksmith who will have the necessary tools and equipment to reprogram the key. They will also have the latest technological know-how and the equipment required to make a Peugeot 208 smart key. The process should not take more than 15 minutes.

Contacts for the battery that are defective

Peugeot changed from the old carbon-encased transponder chips to a new type of chip that uses electronic components on circuit boards. This new system works great when it's fresh, however, over time, the circuit boards start to lose their effectiveness and cease working correctly.

This could prevent the immobiliser's function from being activated, meaning the vehicle won't start. Contact an Peugeot specialist, or a locksmith, if this is the situation.

The most frequent issue is when the battery in the key fob starts to fail. This causes the blade of the key to stop feeding into the lock. A car locksmith can replace the battery and cut a fresh blade for you, this is usually a simple fix.

Faulty Receiver Module

It could be that the receiver module is malfunctioning when your Peugeot key fob fails to function after being dropped on the floor, exposed to a stormy rainstorm, or accidentally washed. The receiver is responsible for sending radio frequency signals to an on-board computer which controls the centralized locking system within your Peugeot vehicle.

The key fob itself has rubber seals that prevent water from reaching the chip inside. Water can damage the chip if it is exposed to the water for an extended period of time. The high salt content of the pool or ocean water could cause damage to the key fob when it is submerged.

The module must be replaced if the Peugeot spare key isn't working anymore. This can only by done by an Peugeot specialist or a professional auto locksmith. In contrast to other vehicles, Peugeot keys are protected by an unique immobilizer system that requires the right coding in order to start the engine. It is for this reason that you should only trust the Peugeot locksmith to create and program the replacement.

Computer on board is not working properly

The on-board computer of your Peugeot is responsible for various functions in your car including power windows and airbags. When something goes wrong in these systems, they will usually show a code that identifies the issue. The code is stored in the system until the issue is resolved. This may require the on-board computers to be replaced.

The most common reason for the warning light for the airbag to flash is corrosion or loose connections within the sensor. This could be due to wear and tear, aging, exposure to salt and moisture. It is crucial to get this issue addressed as soon as you can, as an airbag that is malfunctioning can be dangerous in the event of an accident.

If you see the error "card not found" on your Peugeot, the key battery inside the key fob might be weak or dead. This will stop the key fob from sending a signal to disarm the immobilizer on your vehicle. Test this by pressing the unlock key on the key fob and then trying to start your vehicle. If this does not work then the battery on the key will need replacing.