over 2 years her

If you have ever wondered how to tighten bicycle chain, you are not alone. Many people have experienced this problem and wonder how they can prevent it. The first step is to lift the brake lever. While the lever is up, disconnect the back brake cable. Then, slide the wheel axle towards the dropouts and adjust the tension. Ideally, the chain should be 0.5 inches tighter than it was before. Then, put the wheel axle back into position. Before you begin, you should lubricate the chain with a good quality grease. A rag can be used to remove any excess lubricant.

You can also check if your bike's chain is too loose by moving it half an inch in either direction. Tightening the chain will prevent the bike from jerking when you pedal. Moreover, it will also prevent any interruptions. To tighten a bicycle chain, you should have the rear wheel fitted properly into the frame. Then, you can tighten the nuts while eyeing the position of the rear tire.

To adjust the chain, you should unscrew the nuts holding the rear wheel and tighten the axle bolts. Then, move the chain in an anti-clockwise direction until you achieve the right tension. Pulling the rear wheel back will also adjust the tension. If the chain is too loose, you should tighten the nuts until the chain does not move. If it moves too far, it will prevent the pedals from moving.

To test if your bicycle chain is too loose, you should move the chain about half an inch in either direction. This will tell you whether the chain is too loose or too tight. Make sure that you can see the rear tire in motion before making adjustments. If it moves too far, you should tighten the chain. Otherwise, you will not be able to pedal. If the chain is too loose, you will have to replace it.

After the wheels are securely fixed, you should adjust the bicycle chain. The chain tension of the bicycle is usually determined by removing the nuts and pulling the rear wheel back with the pedals. To check the tension of the chain, pull the rear wheel back and look at the tire's position. If the chain is too loose, it will prevent pedal movement. So, it is better to loosen the chain than to tighten the wheel.

Once you have loosened the nuts on the rear wheel, you need to adjust the tension on the chain. When the chain is too loose, you will not be able to pedal the bicycle. Therefore, you must loosen the nuts on the rear wheel. This will make the chain loose. If the chain is too loose, you should tighten it. Alternatively, you can check the position of the rear wheel. If the rear tire is too far back, you must loosen the axle.